C1130-k9w7-tar.124-3g.JA1.tarl [UPDATED]
DOWNLOAD ->>->>->> https://tlniurl.com/2tw1c6
- C1130: The model number of the access point
- k9w7: The feature set of the image, which stands for crypto and web management
- tar: The file format, which is a compressed archive
- 124-3g.JA1: The software release number, which indicates the version, maintenance level, and special features
Here is a possible title and article with SEO optimization and HTML formatting for the keyword \"C1130-k9w7-tar.124-3g.JA1.tar\":
How to Upgrade Your Cisco Aironet 1130AG Series Access Point with C1130-k9w7-tar.124-3g.JA1.tar
If you have a Cisco Aironet 1130AG Series Access Point, you may want to upgrade or downgrade its software to improve its performance, security, or compatibility. One of the firmware images you can use is C1130-k9w7-tar.124-3g.JA1.tar, which is a crypto and web management image with version 12.4(3g)JA1. In this article, we will show you how to download and install this image on your access point using a TFTP server.
What You Need
Before you start, make sure you have the following:
A Cisco Aironet 1130AG Series Access Point that is connected to a power source and a network
A TFTP server that is reachable from the access point
The C1130-k9w7-tar.124-3g.JA1.tar file that you can download from Cisco or a trusted source
A console cable and a terminal emulator to access the access point's command-line interface (CLI)
Step 1: Download the C1130-k9w7-tar.124-3g.JA1.tar File
The first step is to download the C1130-k9w7-tar.124-3g.JA1.tar file from Cisco or a trusted source. You can use your web browser or an FTP client to do this. Make sure you save the file in a folder that is accessible by your TFTP server.
Step 2: Connect to the Access Point's CLI
The next step is to connect to the access point's CLI using a console cable and a terminal emulator. You can use any terminal emulator that supports serial communication, such as PuTTY or HyperTerminal. The default settings for the access point's console port are:
Baud rate: 9600 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Once you are connected, you should see a prompt like this:
ap>
If you see a prompt like this:
ap#
It means you are already in privileged mode, and you can skip the next step.
Step 3: Enter Privileged Mode
If you are not in privileged mode, you need to enter it by typing enable and pressing Enter. You may be asked for a password, depending on your access point's configuration. If you don't know the password, you can try the default one, which is Cisco. If that doesn't work, you may need to reset the access point to its factory defaults.
Once you are in privileged mode, you should see a prompt like this:
ap#
Step 4: Configure the Access Point's IP Address and Default Gateway
The next step is to configure the access point's IP address and default gateway so that it can communicate with your TFTP server. To do aa16f39245